Genesis Jack 2.0
A deadlift jack under 2 lb that lifts a loaded bar off the floor so you can change plates.
Summarized from REP Fitness's own site and announcements. These are the brand's claims, not ours.
REP Fitness was started in 2012 by brothers Ryan and Shane McGrotty out of a 1,200-square-foot garage storefront in Longmont, Colorado, after they found most strength equipment dated and the buying experience poor. Built on innovation, customer service and value, it grew into a Denver-based home and commercial gym equipment company with an in-house engineering team and an East Coast warehouse in Pennsylvania.
REP says its equipment is designed by in-house engineers, product managers and designers at its Colorado headquarters, and it holds patents on products like the AB-5000 Zero Gap bench.
Every REP Fitness product we carry, scored the same way as everyone else's.
A deadlift jack under 2 lb that lifts a loaded bar off the floor so you can change plates.
A 10 mm, 4-inch uniform leather belt cut to the dimensions some powerlifting federations allow.
A stiff 29 mm power bar with aggressive volcano knurl and IPF marks, made for squat, bench and deadlift.
Classic cast-iron plates with a grip lip and dual lb/kg markings, at a lower price than bumpers.
A flat/incline/decline bench whose sliding seat closes the pad gap at every angle and which stores upright.
The 3x3, 11-gauge home-gym rack with 1-inch hole spacing in the bench zone, so you can set a precise liftoff height.
In Feb 2021 REP recalled about 1,940 PR-4000/PR-5000 strap safety brackets because bad welds could let them detach under a dropped load.
Source 1